Concrete Contractor in Fairview, CA - Driveways and Patios Built for Hillside Lots
Creekstone Hayward Concrete Company is a concrete contractor based in Hayward, CA, building driveways, patios, walks, steps and retaining walls for Fairview homes, with the ground dug out and packed before any concrete goes down.
- Fully licensed and insured.
- Free in-person estimates.
- We respond within 1 business day.
Fairview's hillside lots and what they mean for concrete
Fairview sits east of Hayward and south of I-580, and the houses change as the ground climbs. How close together homes sit roughly follows how high and steep the land is, from apartment complexes to homes with the room of a rural property.
Flatwork is the trade's word for driveways, patios and walks, and it's a funny name for most of what we pour in Fairview. A driveway here often climbs from the street, a patio gets cut into the backyard, and a front walk needs a step halfway up. So the job starts below the surface, with how much dirt comes out, what the slab will sit on and where the rain goes when it comes down the hill.
Concrete work we do for Fairview properties
Concrete driveway building
Fairview driveways often climb from the street, so we dig out to firm ground, pack the base and pitch it so water runs to the street.
Concrete patio construction
On a sloped backyard a patio usually needs some cutting into the hill or some fill, and we pack that ground hard before any concrete goes down.
Stamped concrete services
Stamped concrete gives a patio or walk the look of stone or brick. It sits on a packed base like any slab, because a pattern won't hide settling.
Concrete sidewalk building
Front walks on a sloped lot often need a step built in, and we pitch each run so rain drains off instead of pooling at the door.
Garage floor concrete
An older garage floor that's cracked, sunk or chipped can come out and go back in on a fresh base, thick enough for what you park there.
Decorative concrete
Color, exposed stone and sawn patterns can dress up an entry or patio here, and they last only as long as the base under them.
Concrete retaining walls
Hillside lots here often need a wall to hold back a cut for a driveway or patio, and drainage behind it matters as much as the concrete.
Concrete floor installation
New concrete floors for shops, sheds and barns on the larger lots here go down on a dug-out, packed base, with steel where the load calls for it.
Concrete pool decks
A pool deck takes splashing, bare feet and sun, so we give it a texture that grips and pitch it away from the pool and the house.
Concrete steps construction
Homes set up above the street lean on their front steps, so we set new concrete steps on firm ground rather than loose fill.
Slab foundation building
A slab for an addition or garage on a sloped lot needs the ground cut and packed level first, with steel set inside before the pour.
Foundation installation
On a hillside lot a foundation often steps down with the ground, so we dig and form each level to what the plans call for.
Concrete parking lot building
Apartment complexes and other multi-unit lots here need parking that drains and takes daily traffic, so the base goes deeper and gets packed harder.
Concrete footings
Decks, fences, carports and walls on a slope all stand on footings, so we dig them to firm soil instead of stopping in loose fill.
Foundation raising
When a slab or part of a house has settled on a hillside lot, raising it back up starts with finding out why the ground moved.
Concrete cutting
We cut openings, trenches and clean edges in existing concrete, so a broken section of driveway or walk can come out without tearing up the rest.
A free written concrete estimate for your Fairview job
Send the form and we'll get back to you within one business day. I'll come out and measure, then send a free written estimate, with no obligation, covering what goes under the slab and on top.
(510) 264-7080- Based in
- Hayward, CA 94541
- Hours
- Mon–Sun: 7 AM–11 PM
What working in Fairview means for permits and licenses
Fairview isn't part of the City of Hayward. It's an unincorporated community in Alameda County, so the county is the local government, and building permits for a Fairview address go through the Alameda County Permit Portal, where you can also check a permit's status. I check which office covers your address first, and when the job needs a permit we file it and start once the county signs off, so that review is usually the first thing that moves your schedule. Work that reaches into a county road or the public sidewalk takes its own county permit, and we plan the start date around that review too. Before you hire anyone here, ask for their state contractor's license and their county business license. We're fully licensed and insured.
On the ground, the slope does a lot of the pricing. Where the truck can park on a steep street decides whether we pour straight off the truck or pump the concrete up to the forms, and the size of the job, how much old concrete comes out, how much the hill makes us dig and fill, any wall or steps the grade calls for and the finish all move the price. The schedule turns on the permit, if there is one, and on curing, the days new concrete needs to harden before you put weight on it. Your written estimate prices what goes under the slab as well as what goes on top. We do the same work in Cherryland and Castro Valley.
Fairview slabs crack and sink for two reasons
Most of it is water. On a lot that falls toward the house, rain off the hill runs across the patio or down the driveway and sits against the garage, and over the years it softens the dirt under the slab until a corner drops or water pools where it shouldn't. Water always finds the low spot, and on a hillside the low spot is often your garage. Before I price anything I check where the water runs, and we set the new slab to fall away from the house, with a drain or a curb where the slope needs one.
The rest is fill. Flat spots on a hillside are usually made, not found, by cutting into the hill and pushing the dirt to the low side, and a slab on loose fill settles with it. We dig through to firm ground or pack the fill in layers before any concrete goes in.
How a concrete job runs when you call us in Fairview
Here's how a job goes from your first call or form to the last walk-through, and the points where it helps to have you there.
Call or send the form
Call (510) 264-7080 or send the form with a few lines about the job, and we'll set a time for me to come look at it. Our hours run 7 AM to 11 PM, seven days a week.
I measure and price it
I come out, measure, and ask what the concrete has to carry and how you use the space, so it helps if you're home. The written estimate shows the digging, base and steel under the slab as well as the finish on top, so you can see where the money goes.
Permit, forms and the pour
If you go ahead, we sort out the permit when the job needs one and set the start date around its review. Then our crew digs out, packs the base, sets the forms, pours and finishes with me on site running it, and you don't need to be home on pour day.
Walk the job together
When the crew's done, I walk the finished job with you and tell you when you can walk on it and when you can drive on it. The work is backed by our satisfaction guarantee.
Questions about concrete work in Fairview
Does a concrete contractor from Hayward need a county business license to work in Fairview?
Yes. The county requires a business license for any business working in its unincorporated areas, Fairview included, even if the business is based somewhere else or already holds a license from another city. Ask whoever you hire whether they have one before work starts.
When does a concrete contractor working in Fairview need a California license?
A contractor needs a license from the Contractors State License Board when the job needs a building permit, when they use any other workers, or when the labor and materials on one or more contracts total $1,000 or more. Any job done by a crew, not one person, meets the second test on its own. It's fair to ask anyone you're comparing to show you theirs.
How much does a new concrete driveway cost in Fairview?
The price of a Fairview driveway comes down to its size, how much old concrete comes out, and how much the slope makes us dig, fill and pack before the pour. Thickness, steel, a stamped or colored finish and any steps or wall the grade needs add to it. If the budget's tight, trim the finish and keep the base, because nobody can fix what's under a slab once it's poured. I measure on site and put your figure in writing.
How long before I can drive on a new concrete driveway in Fairview?
You can usually walk on it within a few days, but driving on it takes a longer wait while it cures, and I'll give you both dates for your pour when we finish. Concrete that dries too fast ends up weak and dusty on top, so on hot days we pour early instead of in the midday heat.
What causes concrete driveways and patios to crack on Fairview hillside lots?
Most bad cracks start underneath, with a subgrade, the dirt the slab sits on, that was raked level instead of dug out and packed, or soaked by water running under it. Concrete also shrinks as it hardens, so some cracking is normal, and I'd rather tell you that now than explain it later. We cut control joints, shallow grooves that tell the slab where to crack, soon after the pour, and set rebar, steel bars that hold the pieces together, where the slab needs it.
What is the best way to build a concrete driveway on a sloped lot in Fairview?
The best way is to dig out to firm soil, pack the base in layers, and set the grade so water runs toward the street instead of the garage. On a steep driveway we give the surface a broom finish, a brushed texture that gives tires and shoes grip in the rain. If the edges need a wall or steps to hold the slope, I put that in the same estimate.
Hayward, CA
Tell us about your Fairview concrete job
If you're not sure whether your job needs a permit, ask when you call (510) 264-7080 or send the form, and I'll look it up for your address before I come out.