Creekstone Hayward Concrete CompanyCreekstone Hayward Concrete Company

Concrete Contractor in Union City, CA - Driveways and Patios Built on a Solid Base

Creekstone Hayward Concrete Company is a concrete contractor based in Hayward that pours driveways, patios, walks, steps and foundations in Union City, with the digging, base and drainage done right before any concrete goes in.

Wide concrete driveway with expansion joints leads to a large brick-and-stone house with wooden garage doors.
  • Fully licensed and insured.
  • Free in-person estimates.
  • We respond within 1 business day.

Union City from the flats to the hills

Union City sits between Hayward and Fremont, and on our jobs here it splits into two kinds of work. On the flats around Union City Boulevard it's mostly single-family streets with driveways, patios and side walks that have been down a long time, plus small apartment buildings and shops that need parking. East of Mission Boulevard the lots climb toward the hills, so more of the calls are for steps, retaining walls and driveways on a grade.

That split shapes the job. On the flats it's usually about what's under the old slab and where the water goes, and on the hillside lots it's about holding the ground and getting a driveway to drain without sending water at the garage.

Concrete work we do for Union City homes

  • Concrete driveway building

    When a driveway has sunk at the garage or split down the middle, we tear it out, rebuild the base and pour it to drain toward the street.

  • Concrete patio construction

    Backyards here are often small, so a patio has to work hard. We pour it to fall away from the house so rain doesn't sit against the wall.

  • Stamped concrete services

    Stamped concrete gives a patio or front walk the look of stone or brick, and we place the joints where the pattern hides them.

  • Concrete sidewalk building

    We replace front paths and side-yard walks that have tilted or heaved, with a broom finish that leaves brushed lines for grip when it's wet.

  • Garage floor concrete

    A cracked or stained garage floor in an older house usually needs the base checked before new concrete goes down, so it carries the car's weight evenly.

  • Decorative concrete

    Colored concrete, exposed aggregate and scored patterns let a front entry match the house, and we pick the finish for how much foot traffic it gets.

  • Concrete retaining walls

    On sloped lots toward the hills, a concrete retaining wall holds back the yard so you get flat ground, with drainage behind it so water doesn't push it over.

  • Concrete floor installation

    For a new room, shop or addition, we pour an interior floor flat and level on a packed base, with rebar inside to hold any cracks tight.

  • Concrete pool decks

    Pool decks take bare feet, splashing and chlorine, so we pour them with a texture that grips and slope the water away from the pool and the house.

  • Concrete steps construction

    Front steps that have pulled away from the porch or gone uneven are a trip waiting to happen, so we rebuild them with even risers and solid footings.

  • Slab foundation building

    For a backyard unit, garage or addition, we dig, compact and pour a slab foundation on ground we've checked, because a house slab is hard to redo.

  • Foundation installation

    When a house or addition needs a full foundation, we set the forms, steel and footings to the approved plans and pour it in one go.

  • Concrete parking lot building

    Small apartment buildings and shops here need parking that drains and holds up to cars all day, so we build the base heavier than a home driveway.

  • Concrete footings

    Fences, decks, posts and walls all sit on footings, the concrete under them, and we dig them down to firm ground so they carry the load.

  • Foundation raising

    When a corner of the house has dropped and doors start to stick, we look at what the ground is doing first, then lift and support the foundation.

  • Concrete cutting

    We saw-cut old slabs for removal, openings and plumbing trenches, and cut control joints, the shallow grooves that tell a slab where to crack.

A free written estimate for your Union City concrete job

Send the form and we'll get back to you within one business day. I come out, measure the job myself and send you a written estimate, free and obligation-free.

(510) 264-7080
Based in
Hayward, CA 94541
Hours
Mon–Sun: 7 AM–11 PM

Working in Union City: permits, licenses and what sets the price

Permits for Union City addresses come from the city, not the county, so that's who we file with when your job needs one. If the work touches the street or the public sidewalk, like the stretch where your driveway meets the road, we plan the start date around the city's review, because that's the thing most likely to move a schedule before we ever dig. We're fully licensed and insured, and you don't have to take my word for it, since you can look up any contractor's state license with the Contractors State License Board and ask whether they hold a Union City business license.

Price comes down to the size of the job, whether old concrete has to be broken out and hauled off, how much base work the ground needs, how thick the slab is and how much steel goes in, and the finish on top. Driveways coming off busy roads like Mission Boulevard or Union City Boulevard also take some planning for where the truck sits during the pour. My written estimate spells out the part under the slab as well as the part on top, and it's the same way we work in Hayward and over the hill in Dublin.

Soil, drainage and old slabs in Union City

  1. The city's building design notes mark Soils Hazard Zones east of Mission Boulevard and west of Union City Boulevard. Those are broad areas and not a verdict on your lot, but they're a good reason not to pour on whatever dirt happens to be there, so we dig out to the subgrade, the ground the slab really sits on, look at it and pack a proper base before any concrete goes in.

  2. Most of the slabs we replace here failed for plain reasons. The base was raked flat instead of dug and packed, the joints were cut late or never, or the slab tipped toward the house and sent the rain there. All of that gets settled before the truck shows up, which is why that's where I spend my time.

What to expect when you call us in Union City

From your first call to the final walk-through, here's how a Union City job runs and who you'll be dealing with at each step.

  1. Call us or send the form

    Call (510) 264-7080 or send the form with a few lines about the job. We get back to you and set a time for me to come out.

  2. I measure and check underneath

    I come out, measure, and ask what the concrete has to carry and how you use the space, so it helps if you're home. You get a written estimate that prices what goes under the slab as well as what goes on top, so you can see what the money buys.

  3. We prep, pour and finish

    If the job needs a permit we file it, and the start date waits on the city's review. Then our crew digs out, packs the base, sets forms and rebar and pours, with me on site running it.

  4. Final walk-through with me

    When it's done I walk the job with you and tell you when you can walk on it and when you can drive on it, because curing, the time concrete needs to gain strength, takes longer than most people expect. The work is backed by our satisfaction guarantee.

Questions about concrete work in Union City

How do I find out if my concrete job needs a permit in Union City?

Ask the city's Building Division, which handles over-the-counter permits and plan submittals at its counter. The counter is open Monday through Thursday from 9 a.m. to 5 p.m. and every other Friday from 9 a.m. to noon. If you hire us, we check your address and file the permit when the job needs one.

Does my concrete contractor need a Union City business license?

Yes, the city requires a business license for every business working inside city limits, and it names contractors and out-of-town businesses on that list. So a crew coming in from Hayward or anywhere else needs one too, and it's a fair thing to ask about before you sign.

When does a concrete contractor need a California state license?

A contractor needs a state license when the job needs a building permit, uses any workers, or when labor and materials together come to $1,000 or more on one or more contracts. The state board's exemption covers only small jobs with no permit, no employee labor and a combined value under $1,000. Any job with a crew on it falls outside that.

How much can a contractor ask for as a down payment in California?

On a home improvement job, the state board says a contractor can't ask for or take more than $1,000 or 10 percent of the contract price, whichever is less. That rule covers home improvement work across the state, Union City included.

What affects the cost of a concrete driveway in Union City?

Size, tear-out and the base do most of it. Hauling off an old driveway, extra digging where the ground is soft, a thicker slab with more steel, or a stamped or colored finish all raise the number. The base is the cut people want to make first and the one I talk them out of, because you can redo a finish but you can't fix what's under a slab without starting over.

What causes cracks in concrete driveways in Union City?

Concrete shrinks as it cures, so some cracking is normal, and the control joints we cut give it a place to go. The cracks that cause trouble come from a base that settles, joints cut late, or a pour in midday heat that leaves a weak, dusty top, so we pack the base, cut joints on time and pour early in the day. I'd rather tell you now that concrete cracks than explain it to you later.

Hayward, CA

Tell us about your Union City concrete job

Most of our calls are jobs people put off longer than they'd like, and a sinking slab doesn't get cheaper while it waits, so call (510) 264-7080 or send the form.